melting temperature

Batch mixer experimental results showed that a certain amount of PMDA could increase the chain extension/ branching degree of R-PET, which led to the decrease in melt flow rate, crystallization temperature and melting temperature.

密炼实验结果表明：一定量的均苯四甲酸二酐（PMDA）能够增加R-PET扩链/支化度，从而熔体流动速率减小，结晶温度和熔融温度降低。

Influence of interaction among agglomerative flux components on melting temperature of flux

焊剂组元间交互作用对熔化温度的影响

The results show that as PEG increasing, the crystallizability and melting temperature was decreased.

实验结果表明,随PEG含量的增加, 聚合物的结晶性与熔融温度均下降.

The results show that the addition of Li2O with 0. 04% to 0. 24% ( wt%) could decrease melting temperature by 5-30 ℃ ( 0. 9% Al2O3).

研究结果表明：添加0.04～0.24wt%的氧化锂可以降低熔制温度5～30℃（玻璃中氧化铝含量为0.9wt%）；

Effect of melting temperature on heterogeneous nucleation of Polypropylene Nucleated with different nucleating agents

熔融温度对PP中成核剂的异相成核作用的影响

Practice shows that measurement accuracy of the method is high, error of melting temperature is ± 1 ℃, and time accuracy of melting velocity is 0.1 ms.

生产实践表明：该方法测量精度高，熔化温度误差达±0.1℃，熔化速度时间精度达0.1ms。

The impact of mixing ratio, alkali metals and alkaline earth metals on the ash melting temperature were discussed.

探讨了混合比例以及碱金属和碱土金属等因素对灰熔融温度的影响规律。

The copy principle of DNA is studied by using fractal and fractal dimension theory and hydrogen-bond melting temperature in BDNA copolymers calculated.

利用分形和分维理论研究DNA的复制机理并计算BDNA共聚物中氢键的解链温度。

In this paper, the effect of flux components, flux addition and melting temperature on recovery ratio and impurity content was analyzed.

本文实验研究了熔剂配比、熔剂加入量和熔炼温度等对铸造废铝屑的回收率、合金含杂量的影响。

This approach enable us to simulate the thermal properties including specific heat capacity, melting temperature, thermal expansion coefficient and thermal conductivity of film containing more than 105 atoms easily with ordinary microcomputer.

该方法使我们利用普通微机能很容易地对包含超过105个原子的晶体薄膜的比热、熔化温度、热膨胀系数、热传导系数等热学性质进行模拟。

The bond exhibited typical glass phase with low melting temperature and high bending strength of strips ( 53.62-93.34MPa). The microstructure analysis indicated the enhancement of the bonding strength resulted from the chemical reaction between the vitrified bond and microcrystal alumina ceramic.

结合剂为典型玻璃相，熔融温度较低，试样抗折强度为53.62-93.34MPa，微观分析表明两者间发生了化学反应，增强了结合剂对磨粒的把持力，提高了磨具的强度。

According to different ratio of raw materials for the refining of molten slag and steel temperature measurement balance test, analyzed and discussed refining slag basicity and components of the refining slag and steel melting temperature of inclusions morphology in the same Si 、 Mn deoxidization conditions.

按不同的原料配比进行了精炼渣的熔化温度测定和钢渣平衡试验，在相同的Si、Mn脱氧条件下，分析讨论了精炼渣碱度和组分对精炼渣熔化温度和钢中夹杂物形态的影响。

This eutectic composition has a melting temperature lower than the operating temperature.

这共晶成分的熔化温度低于操作温度.

When Li_2O < 2.5%, the influence of Li2O increasing on reducing of melting temperature is significant, when Li_2O> 2.5%, the influence is not evident;

在Li2O<2.5%的时，增加Li2O对熔化温度的降低作用非常明显，大于2.5%后作用趋缓；

While measuring thermal transition temperature of textile material by differential scanning calorimetry ( DSC), such as melting, crystallization and glass transition temperature, it is discovered that the extrapolated onset temperature and melting temperature deviate to high temperature direction with raising heat-up rate.

用差示扫描量热仪（DSC）测定纺织材料的热转变温度，如熔融温度、结晶温度、玻璃化转变温度时发现：纺织材料的外推起始温度和熔融温度随升温速率增大向高温方向偏移；

It is emphatically expounded the effects of vanadium, titanium, silicon and sulphur on viscosity, melting temperature and solidifying point of liquid iron.

简介了所采用的测试研究方法，着重论述了钛、钒、硅、硫单因素及其综合因素对铁水粘度、熔化性温度和凝固点的影响。

When one reaches the melting temperature, particles break free as the material melts away.

当一个到达熔点时，物体熔化的同时粒子自由破裂。